Porcelain Tiles Grip Finish CLEANING

FIRST FLOOR CLEANING
First floor deep cleaning after installation

After Grouting the Joints (pic. 1) It is important to remove the excess grout with a sponge and clear water (pic. 2). After 12/48 hours, the grout in the joints will have “set up”/hardened significantly. There will be a noticeable residual “haze”. Typically, a diluted acid cleaner specifically for removing “Grout Haze”, combined with a soft scrubbing pad will remove the majority if not all the “Haze”.

Change your acid/water solution frequently for best results. It is also recommended to keep a bucket of clean water to remove the acid/water solution. It is recommended to keep and use clean dry towels to help remove as much residual water and keep the floor as dry as possible. Please refer to the cleaning chemical company’s suggested methods and dilution rates. (pic. 3). For areas with excess grout or grout that becomes adhered to the face of the tile, further cleaning with an Acid/Water Solution may be necessary.

Please refer to the Cleaning Chemical Company’s instructions as not all acids or chemicals are the same. The excess grout residue (pic. 4-5) must be removed so that it does not dry and stick on the surface. It is necessary to change the cleaning water frequently and rinse well. Care must be taken on inlayed, polished and especially Anti Slip products similar to Frontier20.

The use of a floor-washing machine combined with the use of a diluted acid detergent helps reach the spaces between adjacent Tiles Grip Finish and clean them properly. If such a cleaning procedure is not carried out, or if such cleaning is carried out too late, the grout residue creates an absorbent film, which holds dirt, making the surface difficult to clean: in this case, Landmark Ceramics will not be liable for any damage caused to the surface.

ORDINARY CLEANING

Ordinary maintenance must be carried out using specialized detergents to remove stains but these detergents must not leave a wax, film or membrane residue. Rinsing well with plenty of clean water is a fundamental part of the cleaning procedure, therefore we advise against the use of products which state that they “do not need rinsing”.

OTHER RECOMMENDATIONS

Bright colored products, in particular white and extra-white Tiles Grip Finish, are very delicate and, although for all intent and purpose are hygienically clean, However, they can get dirty more easily than darker Tiles Grip Finish. It is therefore necessary to remember that these particular products require careful regular maintenance. Sealers are unnecessary. Sealing will change the D.C.O.F. (Dynamic Co-efficient of Friction) resulting in a surface that will become more slippery. Also because Porcelain has such a low absorption the sealer will unlikely stick and most likely the sealer will flake off over time.
PIC 1. Fill joint with grout.
PIC 2. Remove excess grout with clean water.
PIC 3. Add specific acid cleaning agent for porcelain tile to clean water.
PIC 4. First floor deep cleaning after 12/48 h from installation.
PIC 5. Removal of excess grout residues with hard brush.
NEWSLETTER
Sign up for our Newsletter and get the latest news and cutting-edge insights delivered to your inbox.
subscribe
Job opportunities    We’re hiring! Want to work with us?    Apply here.